Dell PowerVault MD3060e Series Руководство пользователя - Страница 28

Просмотреть онлайн или скачать pdf Руководство пользователя для Хранение Dell PowerVault MD3060e Series. Dell PowerVault MD3060e Series 40 страниц. Storage enclosure
Также для Dell PowerVault MD3060e Series: Руководство по аппаратному и программному обеспечению (25 страниц), Руководство по установке (11 страниц), Руководство по началу работы (10 страниц), Обновление информации (8 страниц), Инструкции по установке стоек (2 страниц), Настройка (2 страниц), Руководство по развертыванию (24 страниц), Руководство администратора (35 страниц), Руководство по началу работы (10 страниц), Руководство по развертыванию (24 страниц), Руководство администратора (48 страниц), Настройка (2 страниц)

Печатать страницу
Dell PowerVault MD3060e Series Руководство пользователя
CAUTION: If you are hot swapping the SAS cable chains, ensure that you complete the
procedure on one side within ten minutes to avoid over heating of the storage enclosure.
2.
Locate and identify the SAS chain cables for the new physical-disk drawer.
3.
Connect the chain cable mounting bracket (oriented horizontally) to the physical-disk drawer.
4.
Connect the chain cable mounting bracket (oriented vertically) to the midplane.
5.
Install the cooling fan module.
6.
Repeat the above mentioned steps for the SAS cable chain on the other side.

Enclosure Management Modules

Removing An Enclosure Management Module

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To avoid damage to the sensitive EMI contacts on the module, do not stack the
modules.
1.
Identify and locate the enclosure management module that you want to replace.
2.
Disconnect the cables connected to the RAID controller module, enclosure management module, or
server.
3.
Push down on the release tab and pull the release lever away from the chassis.
4.
Hold the release lever and pull the module away from the chassis.
28