Dell Force10 S60 Series Snelstarthandleiding - Pagina 22
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dell Force10 S60 Series. Dell Force10 S60 Series 29 pagina's.
Ook voor Dell Force10 S60 Series: Handmatig (45 pagina's)
Pagina afdrukken
Step
Task
Open your terminal software emulation program to access the chassis.
6
Using the terminal settings shown here, set the terminal connection settings.
7
• 9600 baud rate, No parity, 8 data bits, 1 stop bit, No flow control
You will see the message below when you are connected to the chassis.
8
Default Configuration
A version of the Dell Force10 Operating System (FTOS) is pre-loaded onto the
chassis, however the system is not configured when you power up for the first
time (except for the default hostname, which is Force10). You must configure
the system using the Command Line Interface (CLI).
Configure Layer 2 (Data Link) Mode
Use the switchport command in INTERFACE mode to enable Layer 2 data
transmissions through an individual interface. The user can not configure
switching or Layer 2 protocols such as spanning tree protocol on an interface
unless the interface has been set to Layer 2 mode.
Step Task
Enable the interface.
1
Place the interface in
2
Layer 2 (switching)
mode.
To view the interfaces in Layer 2 mode, use the show interfaces switchport
command in the EXEC mode.
Configure a Host Name
The host name appears in the prompt. The default host name is Force10.
•
Host names must start with a letter and end with a letter or digit.
•
Characters within the string can be letters, digits, and hyphens.
20
Installing the Software
Command Syntax
no shutdown
switchport
Command Mode
INTERFACE
INTERFACE