Dell Networking S5000 Configuratiehandleiding - Pagina 9

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Dell Networking S5000. Dell Networking S5000 17 pagina's. Data center switch
Ook voor Dell Networking S5000: Installatiehandleiding (50 pagina's), Configuratiehandleiding (12 pagina's), Aan de slag handleiding (37 pagina's)

Pagina afdrukken
Dell Networking S5000 Configuratiehandleiding
FTOS(conf)#interface range tengigabitethernet 0/0 – 47
Note: The message below will be displayed if there are FC ports.
% Warning: Non-existing ports (non configured) are ingnored by interface-range
FTOS(conf-if-range-te-0/0-47)#switchport
FTOS(conf-if-range-te-0/0-47)#no shutdown
2.8

Enable Jumbo Frames

FTOS(conf-if-range-te-0/0-47)#mtu 12000
2.9

Enable flow control

FTOS(conf-if-range-te-0/0-47)#flowcontrol rx on tx off
2.10

Configure spanning tree on edge ports

FTOS(conf-if-range-te-0/0-47)#spanning-tree rstp edge-port
FTOS(conf-if-range-te-0/0-47)#exit
2.11

Configure port channel for LAG

These commands create a port channel or LAG.
FTOS(conf)#interface Port-channel 1
FTOS(conf-if-po-1)#mtu 12000
FTOS(conf-if-po-1)#switchport
FTOS(conf-if-po-1)#no shutdown
FTOS(conf-if-po-1)#exit
2.12

Configure QSFP ports for LAG

This step assigns the 40Gb QSFP ports to the Port Channel.
FTOS(conf)#interface range fortyGigE 0/48 , fortyGigE 0/52
FTOS(conf-if-range-fo-0/48,fo-0/52)#mtu 12000
FTOS(conf-if-range-fo-0/48,fo-0/52)#no shutdown
9
SCG1007
Dell Networking S5000 Switch Configuration Guide for EqualLogic SANs