Dell PowerConnect 8024F Configuratiehandleiding - Pagina 17
Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Dell PowerConnect 8024F. Dell PowerConnect 8024F 21 pagina's. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Ook voor Dell PowerConnect 8024F: Release-opmerkingen (27 pagina's), Release-opmerkingen (20 pagina's), Implementatiehandleiding (8 pagina's), Firmware upgraden (24 pagina's)
Pagina afdrukken
Note: the switch will reboot.
console>enable
console#configure
console(config)#stack
console(config-stack)#stack-port tengigabitethernet 2/0/21 stack
console(config-stack)#stack-port tengigabitethernet 2/0/22 stack
console(config-stack)#stack-port tengigabitethernet 2/0/23 stack
console(config-stack)#stack-port tengigabitethernet 2/0/24 stack
console(config-stack)#exit
console(config)#exit
4.7
Save configuration (switch 2)
console#copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time.
Are you sure you want to save? (y/n)y
4.8
Final configuration
Power off switch 2, and then connect the cables between the stacked switches (ports 21-24).
Power on switch 2 and wait until it has fully booted.
From the first switch (master) complete the configuration for the stack:
console>enable
console#show switch
Note: Before proceeding ensure that the status for all switches in the stack show OK.
4.9
Disable DCB
Note: The PowerConnect 8024 and 8024F switches do not support Enhanced Transmission Selection
(ETS), therefore Data Center Bridging (DCB) must be manually disabled using the following steps:
console#configure
console(config)#no dcb enable
17
SCG1008
PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs