Dell PowerConnect 8024F Руководство по конфигурации - Страница 17

Просмотреть онлайн или скачать pdf Руководство по конфигурации для Переключатель Dell PowerConnect 8024F. Dell PowerConnect 8024F 21 страница. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Также для Dell PowerConnect 8024F: Информация о выпуске (27 страниц), Информация о выпуске (20 страниц), Руководство по внедрению (8 страниц), Обновление микропрограммы (24 страниц)

Note: the switch will reboot.

console>enable

console#configure

console(config)#stack

console(config-stack)#stack-port tengigabitethernet 2/0/21 stack

console(config-stack)#stack-port tengigabitethernet 2/0/22 stack

console(config-stack)#stack-port tengigabitethernet 2/0/23 stack

console(config-stack)#stack-port tengigabitethernet 2/0/24 stack

console(config-stack)#exit

console(config)#exit

4.7

Save configuration (switch 2)

console#copy running-config startup-config

This operation may take a few minutes.

Management interfaces will not be available during this time.

Are you sure you want to save? (y/n)y

4.8

Power off switch 2, and then connect the cables between the stacked switches (ports 21-24).

Power on switch 2 and wait until it has fully booted.

From the first switch (master) complete the configuration for the stack:

console>enable

console#show switch

Note: Before proceeding ensure that the status for all switches in the stack show OK.

4.9

Note: The PowerConnect 8024 and 8024F switches do not support Enhanced Transmission Selection

(ETS), therefore Data Center Bridging (DCB) must be manually disabled using the following steps:

console#configure

console(config)#no dcb enable

SCG1008

PowerConnect 8024, 8024F, M8024 and M8024-k Switch Configuration Guide for EqualLogic SANs