Dell Z9100-ON Installatiehandleiding - Pagina 12

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dell Z9100-ON. Dell Z9100-ON 43 pagina's. Open networking
Ook voor Dell Z9100-ON: Installatiehandleiding (45 pagina's), Installatiehandleiding (45 pagina's)

Pagina afdrukken
Dell Z9100-ON Installatiehandleiding

Site Preparations

The Z9100–ON is suitable for installation as part of a common bond network (CBN).
You can install the system in:
•
Network telecommunication facilities
•
Data centers
•
Other locations where the National Electric Code (NEC) applies
For more information about Z9100–ON specifications, see Specifications.
NOTE: Install the Z9100–ON system into a rack or cabinet before installing any optional
components.

Site Selection

Install Dell Networking equipment in restricted access areas.
A restricted access area is one in which service personnel can only gain access using a special tool, lock,
key or other means of security and access is controlled by the authority responsible for the location.
Ensure that the area where you install your Z9100–ON system meets the following safety requirements:
•
Near an adequate power source. Connect the system to the appropriate branch circuit protection as
defined by your local electrical codes.
•
Environmental temperature range is from 32° to 113°F (from 0° to 45°C).
•
The switch operating ambient temperature range is from 10° to 35°C (from 50° to 95°F).
•
Relative humidity is from 5 to 85 percent noncondensing.
•
In a dry, clean, well-ventilated and temperature-controlled room, away from heat sources such as hot
air vents or direct sunlight.
•
Away from sources of severe electromagnetic noise.
•
Positioned in a rack or cabinet, or on a desktop with adequate space in the front, back, and sides for
proper ventilation and access.

Cabinet Placement

Install the Z9100–ON only in indoor cabinets designed for use in a controlled environment.
Do not install the Z9100–ON in outside cabinets. For cabinet placement requirements, see
The cabinet must meet minimum size requirements. Airflow must be in accordance with the Electronic
Industries Alliance (EIA) standard. Ensure that there is a minimum of 5 inches (12.7 cm) between the intake
and exhaust vents and the cabinet wall.
12
3
Site
Selection.
Site Preparations