Miele GAS KM 81-2 Gebruiksaanwijzing - Pagina 20

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Miele GAS KM 81-2. Miele GAS KM 81-2 32 pagina's. Gas
Ook voor Miele GAS KM 81-2: Gebruiksaanwijzing (44 pagina's)

Pagina afdrukken

Gas connection

Connection to the gas supply, or

conversion from use on one type of

gas to another should only be

undertaken by an approved Corgi

registered fitter, who is responsible

for correct functioning of the ap-

pliance when installed.

The gas hob is suitable for natural gas

and LPG, and is supplied as standard

for connection to natural gas.

Check with your local Gas Supplier

for details about the type of gas and

calorific value and compare this in-

formation with the type of gas

quoted on the data plate.

For LPG consult your Miele-Dealer

or the Service Department for the

correct gas jet kit.

Instructions for conversion to alterna-

tive forms of gas can be found in the

following Section.

The gas connection must be in-

stalled so that it can be connected

either from inside or outside the kit-

chen unit and the stop-valve must

be easily accessible and visible, by

opening one of the furniture doors,

if necessary.

An appropriate rigid or flexible connec-

tion can be used.

The gas connection must be in accord-

ance with local and national regulations

and should be tested for possible leakage.

The appliance may only be connected

by a registered gas fitter (eg Corgi in

the UK), who is responsible for correct

functioning of the appliance when in-

stalled.

When the gas hob has been in-

stalled, it is essential to check that

neither the gas pipe nor the mains

cable are in contact with hot parts

of the appliance, otherwise tempera-

ture damage to the pipe and the

cable could occur.

Nominal rating for all types of gas at

the high setting:

Gas type

Burner

Natural gas

Liquid gas

Nominal rating for all types of gas at

the low setting:

Gas type

Burner

Natural gas

Liquid gas

Contact your local gas supplier if the

natural gas connection pressure is less

than 18 mbar or higher than 25 mbar.

5.75

5.40

0.20