Allo RemoteControl NICE OX4T Instructies - Pagina 2

Blader online of download pdf Instructies voor {categorie_naam} Allo RemoteControl NICE OX4T. Allo RemoteControl NICE OX4T 4 pagina's.

MEMORISATION OF TRANSMITTERS:

The receiver can memorise up to 1024 transmitters. Compatible with radio encoding "O-

Code" / "FloR" / "TTS", or "Smilo", or "Flo".

Caution!

– These three encoding groups are not compatible with one another; therefore the

first transmitter memorised in the transmitter also defines the encoding family for all the

subsequent transmitters.

To verify whether transmitters are already memorised on the receiver and the relative

encoding group, disconnect the receiver from the power supply, switch on again and count

the number of green flashes, emitted by led L1:

1 flash = Flo encoding

2 flashes = O-Code / FloR / TTS encoding

3 flashes = Smilo encoding

5 flashes = no transmitter memorized

The transmitters can be memorised using one of the following procedures:

Procedure Mode I: programs all keys(*) of the transmitter once only, associating each key

to a relay, according to the following scheme: key 1 = relay 1 / key 2 = relay 2 / key 3 =

relay 3 / key 4 = relay 4. "Mode I" programs each key to operate in "hold-to-run" mode on

the respective relay

Memorising a transmitter in "Mode I":

01. Press and hold P1 on the receiver until the green Led L1 illuminates (after approx. 4

seconds) and then release;

02. Within 10 seconds, press and hold any transmitter key to be memorised, until the green

led L1 on the receiver emits the first of 3 flashes to confirm memorisation. When these

flashes are completed, to memorise another transmitter in "Mode I", press any key on

the new transmitter within 10 seconds.

Memorising a transmitter in "Mode II":

1. In Table A select the function to be programmed (e.g. "Function 8");

2. On the receiver, press P1 the same number of times 7 EN as the number identifying the

selected function (in our example, 8 times). On completion, the green Led L1 emits the

number of short flashes, equal to the number of presses on the key (in our example, 8

short flashes);

3. Within 10 seconds, press and hold any transmitter key to be memorised, until the green led

L1 on the receiver emits the first of 3 flashes to confirm memorisation.

When these flashes are completed, to memorise a new key with the same function (also on

another transmitter) press this new key within 10 seconds.

Visit our website: www.Alloremotecontrol.com