Allo RemoteControl NICE OX4T Instructies - Pagina 4

Blader online of download pdf Instructies voor {categorie_naam} Allo RemoteControl NICE OX4T. Allo RemoteControl NICE OX4T 4 pagina's.

Alternative procedure:

1. On the NEW transmitter, press and hold the key *** for at least 3 seconds and then

release.

2. On the OLD transmitter, press and hold the key *** for at least 3 seconds and then

release.

3. On the NEW transmitter, press the same key pressed in point 01 for at least 3 seconds and

then release.

4. On the OLD transmitter, press the same key pressed in point 02 for at least 3 seconds.

PROGRAMMING A TIMER:

"Timer 1" and "Timer 2" represent the time in which the relays remain active:

Timer 1 used for relay 1. This timer corresponds to the work time of relays 1 and 2, when

programmed with Function 9, 11 or 13.

Timer 2 used for relay 3. This timer corresponds to the work time of relays 3 and 4, when

programmed with Function 10, 12 or 14.

The factory settings of the two Timers is 120 seconds. This value can be modified by means

of the following "self-learning" procedure:

01. If the relay is active, deactivate with the relative command;

02. set dip switch 1 to ON (fig. 3-L) to program Timer 1 or dip switch 2 (fig. 3-M) for Timer

2: the led next to the dip switch illuminates to indicate activation of the programming

phase;

03. according to the selected timer, activate the required relay by means of the relative

key: the time count is then started immediately; 04. when the required time has elapsed,

press the key again to deactivate the relay. The time elapsed has been memorised and will

be applied as the new timer value; 05. return the dip switch to OFF: the led next to the dip

switch turns off and the receiver returns to normal operating status.

Visit our website: www.Alloremotecontrol.com