Overview
This IMG 1010 Quick Start Guide is an abbreviated guide which explains how to connect
power and network cabling. For more information on setup, please either refer to the "IMG
1010 Installation and Setup Guide" on the Technical Publications CD supplied or go to the
Dialogic Technical Support Web Site at
information on installing and setting up the IMG 1010 and GCEMS.
NOTE: To access the Dialogic Technical Support website, you will need a username and
password. To obtain a username and password, you will need support contract with Dialogic.
Once a support contract is obtained, a username and password will be supplied via email.
Shipping Information
Review the packing list to check that all the items listed on the packing list have been sent.
Should any discrepancies exist, contact your Dialogic Representative immediately.
Connecting AC Power
Power Specifications
If the IMG 1010 is powered by AC voltage then the AC input power must conform to the
specifications in the table below. Insert one end of AC cord into rear of IMG 1010 and the
other end into a grounded wall outlet, uninterruptible power supply (UPS), or surge protector.
Power
Frequency
AC Power Module
The AC power docking station provides an AC input power module with an integrated fuse,
power switch, and standard three position female AC input connector. This connector
allows the docking station to interface with all variations of AC outlets by simply using a
standard power cable and compatible outlet plug.
For more information on connecting AC power see IMG 1010 - Installation and Setup Guide
> IMG 1010 - Hardware Installation in either the online documentation or supplied CD.
Dialogic Corporation
IMG 1010 Quick Start Guide
http://www.dialogic.com/support
AC
120 – 240 VAC / 1.5 - 3 Amps
50 or 60 Hz
Part # 07-8728-03
for detailed
Operating Range
90 – 240 VAC
50-60 Hz
Page 4 of 9
Pagina afdrukken