Miller Axcess 675 Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller Axcess 675. Miller Axcess 675 48 pagina's. Automatic welding interface and arc welding power source
Ook voor Miller Axcess 675: Gebruikershandleiding (48 pagina's)

Pagina afdrukken

3-5. Selecting A Location

Movement
Location
Y Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
3
18 in
(460 mm)

3-6. Connection Diagram

2
1
10
9
OR
1
5
3
4
12
11
Tipping
2
4
18 in
(460 mm)
6
7
8
Y Do not move or operate
unit where it could tip.
Y Do not stack units. Beware of
tipping.
1
Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2
Hand Cart
Use cart or similar device to move
unit.
3
Rating Label
Use rating label to determine input
power needs.
4
Line Disconnect Device
Locate unit near correct input
power supply.
loc_2 3/96 -803 822-A
.
The proper interface kit must
be installed in the welding pow-
er source/interface unit to allow
it to be connected to the robot.
1
Robot (Will Vary According To
Application)
2
Motor/Drive Assembly
3
Gas Cylinder
4
Gas Hose
5
Robot Control
6
Robot Input/Output Cable
7
Gas And Motor Control Cable
8
Welding Power
Source/Interface Unit
9
Negative (−) Weld Cable
10 Workpiece
11 Voltage Sensing Lead
(Optional)
.
Positive (+) voltage sensing
lead is contained in the motor
cable.
12 Positive (+) Weld Cable
803 822-A / Ref. 801 915-A
OM-217 751 Page 11