Miller Axcess 675 Manual do Proprietário - Página 15
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura Miller Axcess 675. Miller Axcess 675 48 páginas. Automatic welding interface and arc welding power source
Também para Miller Axcess 675: Manual do Proprietário (48 páginas)
Imprimir página3-5. Selecting A Location
Movement
Location
Y Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
3
18 in
(460 mm)
3-6. Connection Diagram
2
1
10
9
OR
1
5
3
4
12
11
Tipping
2
4
18 in
(460 mm)
6
7
8
Y Do not move or operate
unit where it could tip.
Y Do not stack units. Beware of
tipping.
1
Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2
Hand Cart
Use cart or similar device to move
unit.
3
Rating Label
Use rating label to determine input
power needs.
4
Line Disconnect Device
Locate unit near correct input
power supply.
loc_2 3/96 -803 822-A
.
The proper interface kit must
be installed in the welding pow-
er source/interface unit to allow
it to be connected to the robot.
1
Robot (Will Vary According To
Application)
2
Motor/Drive Assembly
3
Gas Cylinder
4
Gas Hose
5
Robot Control
6
Robot Input/Output Cable
7
Gas And Motor Control Cable
8
Welding Power
Source/Interface Unit
9
Negative (−) Weld Cable
10 Workpiece
11 Voltage Sensing Lead
(Optional)
.
Positive (+) voltage sensing
lead is contained in the motor
cable.
12 Positive (+) Weld Cable
803 822-A / Ref. 801 915-A
OM-217 751 Page 11