Miller Spoolmatic 30A Gebruikershandleiding - Pagina 18
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Miller Spoolmatic 30A. Miller Spoolmatic 30A 32 pagina's. Welding guns
Ook voor Miller Spoolmatic 30A: Gebruikershandleiding (32 pagina's), Gebruikershandleiding (36 pagina's)
Pagina afdrukken
7-3. Gun Drive Assembly Maintenance
3
1
Tools Needed:
5/16 in.
OM-1213 Page 14
2
4
Retract wire onto spool.
1
Setscrew
2
Current Pick-Up Tab
This tab helps prevent burnback
caused by welding arcs inside the
contact tip. This tab may be re-
moved to provide an insulated drive
roll. (If tab is removed, a smaller di-
ameter contact tip is recom-
mended. See options in Parts List.)
Lightly grease top of tab before rein-
stalling.
3
Drive Roll
Use wire brush to clean drive roll.
Install drive roll with desired groove
down, and turn drive roll so one set-
screw faces flat side of shaft.
4
Bearing
Use wire brush to clean bearing.
Line up drive roll groove with bear-
ing groove and liner opening. Tight-
en setscrews.
Thread welding wire through gun
(see Section 5-2). Close and se-
cure pressure roll assembly. Adjust
drive roll pressure, if necessary
(see Section 5-7). Reinstall top cov-
er.
Ref. 149 967-H / Ref. 800 945-A