Panasonic WV-SW316L Installatiehandleiding - Pagina 23
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Panasonic WV-SW316L. Panasonic WV-SW316L 50 pagina's. Ip video cameras
Ook voor Panasonic WV-SW316L: Specificatie (2 pagina's), Integratie Opmerking (8 pagina's)
Pagina afdrukken
Waterproof treatment for the cable joint sections
Adequate waterproof treatment is required for the cables when installing the camera with cables
exposed or installing it under the eaves. The camera body is waterproof, but the cable ends are not
waterproof.
Be sure to use the supplied waterproof tape at the points where the cables are connected to apply
waterproof treatment in the following procedure. Failure to observe this or use of a tape other than
the provided waterproof tape (such as a vinyl tape) may cause water leakage resulting in malfunc-
tion.
LAN cable
Wind the tape in a
half-overlapping manner.
Wind the tape in a
half-overlapping manner.
Alarm input/output cable, power cable, microphone/line input cable, audio output cable
SW316L
SW316
Wind the tape in a
half-overlapping manner.
Wind the tape in a
half-overlapping manner.
IMPORTANT:
• Waterproof treatment is also to be applied to the 2P power cable (accessory), the 4P alarm
cable (accessory) and other connection cables if they are subject to rain.
Note:
How to wind the supplied waterproof tape
• Stretch the tape by approx. twice (see the illustration)
and wind it around the cable. Insufficient tape stretch
causes insufficient waterproofing.
• Make sure to wind the tape so that it does not press
down on the hook of the network cable.
• To install this product outdoors, be sure to waterproof
the cables. Waterproof grade (IEC IP66 or equivalent)
is applied to this product only when it is installed cor-
rectly as described in these operating instructions and
appropriate waterproof treatment is applied. The mount
brackets are not waterproofed.
Stretch the tape to
about twice.
hook
2x
23