Panasonic WV-SW316L Kurulum Kılavuzu - Sayfa 23

Video Kamera Panasonic WV-SW316L için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Panasonic WV-SW316L 50 sayfaları. Ip video cameras
Ayrıca Panasonic WV-SW316L için: Şartname (2 sayfalar), Entegrasyon Notu (8 sayfalar)

Sayfayı Yazdır

Waterproof treatment for the cable joint sections

Adequate waterproof treatment is required for the cables when installing the camera with cables

exposed or installing it under the eaves. The camera body is waterproof, but the cable ends are not

waterproof.

Be sure to use the supplied waterproof tape at the points where the cables are connected to apply

waterproof treatment in the following procedure. Failure to observe this or use of a tape other than

the provided waterproof tape (such as a vinyl tape) may cause water leakage resulting in malfunc-

tion.

LAN cable

Wind the tape in a

half-overlapping manner.

Wind the tape in a

half-overlapping manner.

Alarm input/output cable, power cable, microphone/line input cable, audio output cable

SW316L

SW316

Wind the tape in a

half-overlapping manner.

Wind the tape in a

half-overlapping manner.

IMPORTANT:

• Waterproof treatment is also to be applied to the 2P power cable (accessory), the 4P alarm

cable (accessory) and other connection cables if they are subject to rain.

Note:

How to wind the supplied waterproof tape

• Stretch the tape by approx. twice (see the illustration)

and wind it around the cable. Insufficient tape stretch

causes insufficient waterproofing.

• Make sure to wind the tape so that it does not press

down on the hook of the network cable.

• To install this product outdoors, be sure to waterproof

the cables. Waterproof grade (IEC IP66 or equivalent)

is applied to this product only when it is installed cor-

rectly as described in these operating instructions and

appropriate waterproof treatment is applied. The mount

brackets are not waterproofed.

Stretch the tape to

about twice.

hook