Panasonic WVNP244 - COLOR CCTV CAMERA Gebruiksaanwijzing - Pagina 15

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Panasonic WVNP244 - COLOR CCTV CAMERA. Panasonic WVNP244 - COLOR CCTV CAMERA 24 pagina's. Ip video cameras
Ook voor Panasonic WVNP244 - COLOR CCTV CAMERA: Gebruiksaanwijzing (24 pagina's), Specificaties (2 pagina's), Brochure (2 pagina's), Referentie (2 pagina's), Referentie (2 pagina's), Handmatig (2 pagina's), Gebruiksaanwijzing (24 pagina's), Integratie Opmerking (8 pagina's)

Pagina afdrukken
Panasonic WVNP244 - COLOR CCTV CAMERA Gebruiksaanwijzing
<For the WV-NP244>
Connect the power cable.
• When using AC 24 V/DC 12 V power
supply
SD
EXT I/O
CARD
1 2 3 4
POWER
GND
AC 24V IN : 1L – 2N
DC 12V IN : ! – @
GND wire
• When using PoE (Power over Ethernet:
IEEE802.3af compliant)
Connect a LAN cable (category 5 or bet-
ter) between a PoE device (such as a
PoE hub) and the network connector of
the camera.
Important:
• Use all of 4 pairs (8 pins) of the LAN
cable.
• The maximum cable length is 100 m.
• Make sure that the PoE device in use is
compliant with IEEE802.3af standard.
• When connecting both the AC 24 V/DC
12 V power supply and the PoE device
for power supply, PoE will be used for
power supply.
• When disconnecting the LAN cable
once, connect the cable again after 2
seconds or more from the disconnection.
When the cable is connected before 2
seconds passed, the power may not be
supplied from the PoE device.
• Refer to the provided slip (Recommend-
ed network devices for PoE (IEEE802.3af
compliant) connection with the WV-
NP244) for applicable PoE devices.
–
+
AC24 V
DC12 V
Step 4
Connect a LAN cable (category 5 or better)
to the network connector on the rear of the
camera.
10BASE-T/
MONITOR OUT
LINK
100BASE-TX
ACT
INITIAL SET
SD
EXT I/O
CARD
1 2 3 4
POWER
GND
AC 24V IN : 1L – 2N
DC 12V IN : ! – @
WV-NP244 is shown above.
Step 5
Connect an external device to the EXT I/O
connector.
When connecting an external device, remove
9 mm – 10 mm of the outer jacket of the
cable and twist the cable core to prevent the
short circuit first.
ALARM OUT
(Alarm out terminal)
ALARM IN
(Alarm in terminal)
AUX OUT
(AUX out terminal)
GND
Specification of cable (wire):
AWG #22 - #28
Single core, twisted
Important:
• Do not connect 2 wires or more directly
to a terminal. When it is necessary to
connect 2 wires or more, use a splitter.
LAN cable
Cut
Approx.
9 mm - 10 mm
15