Panasonic WVNP244 - COLOR CCTV CAMERA Kullanım Talimatları Kılavuzu - Sayfa 15

Video Kamera Panasonic WVNP244 - COLOR CCTV CAMERA için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Panasonic WVNP244 - COLOR CCTV CAMERA 24 sayfaları. Ip video cameras
Ayrıca Panasonic WVNP244 - COLOR CCTV CAMERA için: Kullanım Talimatları Kılavuzu (24 sayfalar), Teknik Özellikler (2 sayfalar), Broşür (2 sayfalar), Referans (2 sayfalar), Referans (2 sayfalar), Manuel (2 sayfalar), Kullanım Talimatları Kılavuzu (24 sayfalar), Entegrasyon Notu (8 sayfalar)

Sayfayı Yazdır

Panasonic WVNP244 - COLOR CCTV CAMERA Kullanım Talimatları Kılavuzu

Connect the power cable.

• When using AC 24 V/DC 12 V power

supply

EXT I/O

CARD

1 2 3 4

POWER

GND

AC 24V IN : 1L – 2N

DC 12V IN : ! – @

GND wire

• When using PoE (Power over Ethernet:

IEEE802.3af compliant)

Connect a LAN cable (category 5 or bet-

ter) between a PoE device (such as a

PoE hub) and the network connector of

the camera.

Important:

• Use all of 4 pairs (8 pins) of the LAN

cable.

• The maximum cable length is 100 m.

• Make sure that the PoE device in use is

compliant with IEEE802.3af standard.

• When connecting both the AC 24 V/DC

12 V power supply and the PoE device

for power supply, PoE will be used for

power supply.

• When disconnecting the LAN cable

once, connect the cable again after 2

seconds or more from the disconnection.

When the cable is connected before 2

seconds passed, the power may not be

supplied from the PoE device.

• Refer to the provided slip (Recommend-

ed network devices for PoE (IEEE802.3af

compliant) connection with the WV-

NP244) for applicable PoE devices.

–

AC24 V

DC12 V

Step 4

Connect a LAN cable (category 5 or better)

to the network connector on the rear of the

camera.

10BASE-T/

MONITOR OUT

LINK

100BASE-TX

ACT

INITIAL SET

EXT I/O

CARD

1 2 3 4

POWER

GND

AC 24V IN : 1L – 2N

DC 12V IN : ! – @

WV-NP244 is shown above.

Step 5

Connect an external device to the EXT I/O

connector.

When connecting an external device, remove

9 mm – 10 mm of the outer jacket of the

cable and twist the cable core to prevent the

short circuit first.

ALARM OUT

(Alarm out terminal)

ALARM IN

(Alarm in terminal)

AUX OUT

(AUX out terminal)

GND

Specification of cable (wire):

AWG #22 - #28

Single core, twisted

Important:

• Do not connect 2 wires or more directly

to a terminal. When it is necessary to

connect 2 wires or more, use a splitter.

LAN cable

Cut

Approx.

9 mm - 10 mm