HP StorageWorks 2/32 - SAN Switch Handleiding voor installatie-instructies - Pagina 5

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} HP StorageWorks 2/32 - SAN Switch. HP StorageWorks 2/32 - SAN Switch 6 pagina's. Fabric manager version 3.0.x release notes
Ook voor HP StorageWorks 2/32 - SAN Switch: Handleiding voor installatie-instructies (20 pagina's), Gebruikershandleiding (22 pagina's), Opmerkingen over firmware-uitgave (14 pagina's), Release Release (48 pagina's), Release Release (32 pagina's), Release Release (14 pagina's), Release Release (4 pagina's)

• To attach the inner rails to the SAN Switch 2/32, use the screw

holes marked 32.

• To attach the inner rails to the 4/8, 4/16, 8/8, or 8/24 SAN

Switch, use the five screw holes marked 8. The plenum requires

one screw hole marked 8 and one screw hole marked 16, as

shown in

Figure 8

on page 6.

• To attach the inner rails to the 4/32, 4/32B, 4/64, 8/40, or

8/80 SAN Switch, or the 400 MP Router, use the screw holes

marked 16, as shown in

• To attach the inner rails to the MP Router, FCoE Converged

Network Switch, or Encryption SAN Switch, use two screw holes

marked R and one screw hole marked 16.

CAUTION:

Be sure to use the screw holes labeled 8 when attaching

the inner rails to the SAN Switch 2/16V or SAN Switch

2/16N.

Figure 7

on page 5.

Secure the two inner rails (one on each side) to the device using

the appropriate number of screws. (See

For example,

Figure 6

with three screws, using two screw holes marked R and one screw

hole marked 16. Attaching both rails requires six screws.

Figure 7

shows an inner rail attached to the 4/64 SAN Switch with

five screws, using the screw holes marked 16. Attaching both rails

requires ten screws.

Figure 6 Securing the inner rails to the MP Router

Figure 7 Securing the inner rails to the 4/64 SAN Switch

NOTE:

For factory integration only , tighten the #8-32 x

5/16-inch Phillips panhead SEMS screws and torque

between 6 and 8 inch-pounds.

Page 5

Table

2.)

shows an inner rail attached to the MP Router

MR 25007a

I O

L N

S P

MR 2 5018b