HP StorageWorks 8B - FC Entry Switch Handleiding voor installatie-instructies - Pagina 14

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 20 pagina's. Fabric os release notes version 3.0.1b
Ook voor HP StorageWorks 8B - FC Entry Switch: Handleiding bijwerken (9 pagina's), Gebruikershandleiding (22 pagina's), Opmerkingen over firmware-uitgave (14 pagina's), Installatiehandleiding (14 pagina's), Release Release (26 pagina's), Handmatig (50 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (37 pagina's), Gebruikershandleiding (30 pagina's), Release Release (16 pagina's)

Figure 6: Assembling the outer rails (HP System/e rack)

5. Determine the number of #8-32 x 3/16-inch Phillips pan-head screws with

Table 1: Number of screws required to assemble the inner rails

SAN Switch 2/32

SAN Switch 2/16

SAN Switch 2/8

— For an HP System/e rack, install two #10-32 x 1/2-inch Phillips pan-head

screws with captive star lock washers and two #10 alignment washers in

the upper and lower hole locations of the right rail. Then install two

#10-32 x 1/2-inch Phillips pan-head screws with captive star lock washers

and two #10 alignment washers in the upper and lower hole locations of

the left rail. See

thread lock required to assemble the inner rails by referring to

Switch

Figure

Number of #8-32 x 3/16-inch Screws

SAN Switch Rack Mount Kit Installation Instructions

Table