HP StorageWorks 8B - FC Entry Switch Installatiehandleiding - Pagina 3

Blader online of download pdf Installatiehandleiding voor {categorie_naam} HP StorageWorks 8B - FC Entry Switch. HP StorageWorks 8B - FC Entry Switch 14 pagina's. Fabric os release notes version 3.0.1b
Ook voor HP StorageWorks 8B - FC Entry Switch: Handleiding bijwerken (9 pagina's), Handleiding voor installatie-instructies (20 pagina's), Gebruikershandleiding (22 pagina's), Opmerkingen over firmware-uitgave (14 pagina's), Release Release (26 pagina's), Handmatig (50 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (44 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (38 pagina's), Gebruikershandleiding (37 pagina's), Gebruikershandleiding (30 pagina's), Release Release (16 pagina's)

Installing the Switch in a Rack Using the SAN Switch Universal

Rack Mount Kit

This section provides instructions for installing the SAN Switch 2/32, SAN

Switch 2/16, or SAN Switch 2/8 in an HP System/e rack, or in an HP 9000 Series

or comparable EIA rack using the SAN Switch Universal Rack Mount Kit, part

number 331148-B21.

Figure 1: SAN Switch 2/16 rack-mounted switch

Note:

The following items are required to install the switch in a rack:

HP StorageWorks SAN Switch 2/8|16|32 Installation Guide

Installing the Switch in a Rack Using the SAN Switch Universal Rack Mount Kit

The Universal Rack Mount Kit installation requires two technicians.

SAN Switch 2/32, SAN Switch 2/16, or SAN Switch 2/8

Power cables

#2 Phillips screwdriver

7/16-inch wrench or socket

The SAN Switch Universal Rack Mount Kit rails and rail mounting hardware

listed below:

(2) Rear mounting brackets

Addendum Pg