HP StorageWorks director 2/140 Handleiding voor installatie-instructies - Pagina 13
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} HP StorageWorks director 2/140. HP StorageWorks director 2/140 22 pagina's. Universal port module kit
Ook voor HP StorageWorks director 2/140: Handleiding voor installatie-instructies (24 pagina's)
Pagina afdrukken
Required Items
Check that the following items are available before beginning the installation.
•
#2 Phillips screwdriver
•
Lift device (recommended)
Rack Mounting Guidelines
This section describes guidelines for installing more than one Director and positioning
the Director 2/140 on the lift device.
Tips for Installing More than One Switch
Review the following tips:
•
Install the first Director in the lowest position of the rack, allocated for switches.
•
Consider leaving a space of 1U open at the top and bottom of the rack, to allow
easier cabling access.
•
If installing more than one Director 2/140 in a single rack, consider leaving a
space of 1U open above and below each Director to allow easier cabling access.
•
If installing more than one switch, HP recommends installing an optional Power
Distribution Unit (PDU) in the bottom of the rack. HP ships two PDU power cords
with the Director 2/140.
•
Make sure to connect power cables as you install each individual switch.
director 2/140 rack mount kit installation instructions
Installation Instructions
3