aquatherm AT115 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} aquatherm AT115. aquatherm AT115 10 pagina's.

Pagina afdrukken

Water Coming from the Heat Pump..

Is it a leak or just condensation from normal operation?

Here's how to find out.

Test the water draining out the heater base for the presence of the sanitizer

being used in the pool or spa. Using a water test kit, or a test strip, check a

sample of the water for chlorine or bromine. If the sample tests positive for

sanitizer, call Aquatherm for service at: 239-482-0606. If the test is negative,

the water is probably harmless condensation.

Or, as an alternate method, shut the heat pump off, leaving the circulation

pump running. Within a few hours, there should be a marked reduction in

the amount of water seen around the bottom of the heat pump. If the water

appears to be drying up, the water is probably harmless condensation, indica-

tive of normal operation.

NOTE: The water test method will not be effective if an ionizer or ozone gen-

erator is being used to produce the sanitizing agent.

CAUTION! If after testing, a water leak is suspected, immediately shut OFF

the water pump and contact Aquatherm Customer Support: 239-482-0606.

SAFETY INFORMATION

Used and maintained properly, your heat pump will provide years of safe and

economical service. However, as with any mechanical or electrical device,

to get the most from your heat pump-while insuring personal safety for you

and others-certain operational and maintenance factors must be observed.

Except for a few minor owner-capable maintenance items (explained later in

this manual), repair and service of your heat pump must be performed only by

licensed service personnel. If you suspect your heat pump is not performing

properly, refer to the Troubleshooting section in this manual to determine if

service is required. Your installer can be one source of service, or you can call

Aquatherm at (239) 482-0606 or 888-297-3826. For questions concerning

installation, modifications, operation, service and upkeep, please contact your

installer or Aquatherm Customer Support.

WARRANTY MAY BE VOIDED IF THE HEATER HAS BEEN

USED, MAINTAINED, OR REPAIRED IMPROPERLY.

In addition to voiding the manufacturer's warranty, unapproved installation

methods, nonstandard modifications, poor or incorrect maintenance, service

by unqualified personnel, or improper use of the heater may result in personal

injury and/or property damage. For personal safety, and to avoid damage to

equipment, follow all safety instructions displayed on the heat pump and

within this manual.

CONTENTS

Model/Serial # ....................................................................Cover

Heat Pump Options ....................................................................1

How A Heat Pump Works ..........................................................1

Heating Quick Start & Stop ................................................. 2 - 3

Heater Controls ..........................................................................4

Operational & Programming Codes ...........................................5

Operational & Maintenance Recommendations ........................6

Maintenance & Operation .................................................... 7 - 8

Proper Water Flow

Water Chemistry Standards

Pool & Spa Refinishing

Irrigation and Storm Run-Off

Proper Clearances

Heating Tips ...............................................................................9

Seasonal Use & Shut Down .....................................................10

Freeze Protection .....................................................................10

Recommended Maintenance ....................................................11

Troubleshooting ............................................................... 12 - 13

Safety Information ...................................................................13

Aquatherm Contact Information ...............................Back Cover