Diamond Vantage TS400 Gebruikershandleiding - Pagina 11

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Vantage TS400. Diamond Vantage TS400 20 pagina's.

Pagina afdrukken

(A)

(B)

Cover of grounded

Grounding Pin

Repair or replace damaged or worn cord immediately.

This tool is intended for use on a circuit with an outlet

as illustrated in Figure 2. The tool's grounding plug is

illustrated in Figure 2(A). A temporary adapter (Figure

2(B) and 2(C) may be used to connect this plug to a 2

pole receptacle as shown in Figure 2(B) if a properly

grounded outlet is not available. The temporary adapter

should be used only until a properly grounded outlet can

be installed by a qualified electrician. The lug extending

from the adapter must be connected to permanent

ground such as a properly grounded outlet box.

Additionally, water pump requires the use of a Ground

Fault Circuit Interrupter. Therefore, when using the water

pump receptacle, this tool must be plugged into a properly

installed Ground Fault Circuit Interrupter outlet. See

Figure 2(D). If a Ground Fault Circuit Interrupter outlet is

not available, Diamond Vantage

accessory item. A plug-in Ground Fault Circuit Interrupter

may be plugged into a properly installed and grounded

3-pole outlet. Refer to Figure 2(E).

Figure 2: GROUNDING METHODS

outlet box

Grounding

Means

(Lug)

has it available as an

• 11 • diamondvantage.com

(C)

(D)

Metal

Screw

NOTE

- Use of a Temporary Adapter is not permitted

in Canada.

20. POSITION OF THE TILE SAW

• To avoid the possibility of the appliance plug

or electrical outlet getting wet, position the tile

saw to the side of the wall mounted outlet box to

prevent water from dripping onto it or the plug.

The user should arrange a "drip loop" in the cord

connecting the saw to the electrical outlet. Create

a "drip loop" by placing part of the cord below

the level of the electrical outlet, or the connector

if an extension cord is used. This will prevent

water from traveling along the cord and coming in

contact with the electrical outlet.

• Do not unplug the cord if the electrical outlet

gets wet. Disconnect the fuse or circuit breaker

that supplies power to the tool. Then unplug and

examine for presence of water in the electrical

outlet.

To reduce the risk of electrocution, keep

all connections dry and off the ground. Do

not touch plug with wet hands.

(E)