Diamond Vantage TS400 Gebruikershandleiding - Pagina 12

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Diamond Vantage TS400. Diamond Vantage TS400 20 pagina's.

VIII. TS400: SAFE OPERATING PRACTICES FOR TILE SAW

21. EXTENSION CORDS

• Only use extension cords that are intended for

outdoor use and marked "Acceptable for use with

outdoor appliances; store indoors while not in use."

Only use extension cords with the electric rating

of the machine or above. Do not use damaged

or repaired extension cords. Examine extension

cords before using and replace if damaged. Do

not abuse extension cords and do not yank on any

cord to disconnect. Keep cords away from heat and

sharp edges. Always disconnect the extension cord

from the electrical outlet before disconnecting the

product from the extension cord.

IX. TS400: USING THE CUTTING TABLE

FEATURES:

• Cutting table marked in inches for precision cuts.

• 14" cutting table provides more support during larger

cutting jobs than the standard 11" cutting tables.

USING 90º EDGE GUIDE:

Set the edge guide positioning it on the desired

dimension and tighten the threaded knob. Make

sure that the edge guide is firmly tightened to avoid

slippage. The edge guide can be used for 90º edge

cuts from both the left and right side.

14" cutting table provides more support during larger

cutting jobs than the standard 11" cutting tables.

Simply line-up the material being cut with the

appropriate pre-marked lines on the cutting table

surface.

Now you are ready to make your cut.

MAKING MITER CUTS

• 12 • diamondvantage.com

• Ground Fault Circuit Interrupter (GFCI) protection

should be provided on the circuit(s) or outlet(s)

to be used for the tile saw. Electrical outlet with

built-in GFCI protection may be used for this

measure of safety.

For miter cuts, place the lip of the miter block on the

measurement rail, with the threaded knobs facing you.

Tighten the threaded knobs to secure the provided miter

block in place.

Place material onto miter block and you are ready to cut.