EasyPet EP-28A Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} EasyPet EP-28A. EasyPet EP-28A 9 pagina's. Automatic anti-bark collar

Step 5 Builtin Safety Feature

When the collar reaches highest correction level, and your dog continues to bark more than 10

times within one minute period, the collar will go into safety mode for 3 minutes. When collar

unit is in safety mode, it will only give three short indicator beeps when triggered and will not

give any other corrections.

Step 6 Using the Collar

6.1 Fit the Collar to Your Dog

A proper fit is important for EP28A collar to function properly on your dog. Make sure the

collar is off before placing it on your dog.

Have your dog standing comfortably and place the probes around half inch above or below the

dog's Adam's Apple. The probes must be in direct contact with the dog's skin. Excess hair on

the dog's neck can be parted with your fingers, thinned by brushing, or trimmed with scissors.

Do not shave its neck as it may cause a rash or infection.

Fit the strap as snugly as possible, without restricting breathing. You should be able to fit one

finger between the strap and your dog's skin at the back of its neck. Allow your dog to wear

the collar for several minutes, then recheck the fit. Check the fit again as your dog becomes

more comfortable with the EP28A collar. Remove the collar and trim the excess.

Your Dog's First Session

The collar is active when the battery is fully charged. Simply put the collar on your dog and

enjoy the peace and quiet!

Monitor your dog during his first session. This is when he will learn what the collar means.

Dogs learn at different speeds. It may take several barks or even several sessions for your

dog to reduce his barking. Don't worry the autoset feature will start at the lowest level and

adjust to the right level to motivate your dog to stop barking. The collar will remember the

correct level between uses.

Resetting the Collar

If you wish to reset the collar back to the lowest level, simply turn off the collar and turn it back

on. The collar will now be on the lowest level.