EasyPet EP-28A Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Средство для ухода за домашними животными EasyPet EP-28A. EasyPet EP-28A 9 страниц. Automatic anti-bark collar
Step 5 Builtin Safety Feature
When the collar reaches highest correction level, and your dog continues to bark more than 10
times within one minute period, the collar will go into safety mode for 3 minutes. When collar
unit is in safety mode, it will only give three short indicator beeps when triggered and will not
give any other corrections.
Step 6 Using the Collar
6.1 Fit the Collar to Your Dog
A proper fit is important for EP28A collar to function properly on your dog. Make sure the
collar is off before placing it on your dog.
Have your dog standing comfortably and place the probes around half inch above or below the
dog's Adam's Apple. The probes must be in direct contact with the dog's skin. Excess hair on
the dog's neck can be parted with your fingers, thinned by brushing, or trimmed with scissors.
Do not shave its neck as it may cause a rash or infection.
Fit the strap as snugly as possible, without restricting breathing. You should be able to fit one
finger between the strap and your dog's skin at the back of its neck. Allow your dog to wear
the collar for several minutes, then recheck the fit. Check the fit again as your dog becomes
more comfortable with the EP28A collar. Remove the collar and trim the excess.
Your Dog's First Session
The collar is active when the battery is fully charged. Simply put the collar on your dog and
enjoy the peace and quiet!
Monitor your dog during his first session. This is when he will learn what the collar means.
Dogs learn at different speeds. It may take several barks or even several sessions for your
dog to reduce his barking. Don't worry the autoset feature will start at the lowest level and
adjust to the right level to motivate your dog to stop barking. The collar will remember the
correct level between uses.
Resetting the Collar
If you wish to reset the collar back to the lowest level, simply turn off the collar and turn it back
on. The collar will now be on the lowest level.