Olympus BH2 Series Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Olympus BH2 Series. Olympus BH2 Series 9 pagina's. Phase contrast
Ook voor Olympus BH2 Series: Handleiding voor probleemoplossing en afstelling (46 pagina's), Volledige demontage, reiniging en hermontage (23 pagina's), Volledige demontage, reiniging en hermontage (40 pagina's), Demontage, reiniging en hermontage (45 pagina's), Handmatig (6 pagina's)

Last update: 2021/09/23 17:15

Vertical adjustment screws

Installing the Drive & Brass Clutch Plate

Use the 7/64 Allen wrench to loosen the clamp that is located on the ASI drive shaft. This clamp is

located at the end of the drive shaft as it protrudes out of the black encoder cover. Once the clamp is

loose slide it back towards the encoder and slide the brass clutch plate onto the ASI drive shaft. The

clutch plate should slide onto the drive shaft with the milled out portion pointing away from the

encoder. While holding the right ﬁne focus knob slide the motor drive and back plate assembly in

towards the microscope, when the ASI drive shaft is close enough, position the hollow end of the drive

shaft (protruding from the black encoder) over the ﬁne focus shaft on the microscope. Orient the

motor assembly so that the two shafts are aligned, and then push the motor assembly onto the

microscope. If you do not hold the right ﬁne focus knob the microscope's ﬁne focus shaft may be

pressed over towards the right of the microscope. If this happens simply push the right ﬁne focus

knob in towards the microscope to push the shaft back.

Press the drive onto the microscope until the side of the back plate assembly slides against the side

of the microscope, or if installing the drive and back plate separately: push the drive on until the tab

on the adjustment bar seats into the grove on the back plate. While holding the drive in place with

one hand use a screw driver to press the clamp against the brass clutch plate and press the brass

plate against the wave washer and focus shaft. Hold this in place and use the 7/64 inch hex wrench to

securely tighten the clamp. Note The Clamp Must Be Securely Tightened or the drive and

clutch may slip.

https://asiimaging.com/docs/

oly_bh2_zdrive_installation https://asiimaging.com/docs/oly_bh2_zdrive_installation

Printed on 2021/10/12 04:32