Circe Cycles Morpheus Montagehandleiding - Pagina 5

Blader online of download pdf Montagehandleiding voor {categorie_naam} Circe Cycles Morpheus. Circe Cycles Morpheus 8 pagina's.
Ook voor Circe Cycles Morpheus: Gebruikershandleiding (10 pagina's)

Pagina afdrukken

INSTALLING THE BOOM

First, remove any packaging from around the

end of the main tube on the bike, including the

transportation bung, which is inserted into the

end of the boom to prevent damage. The boom

can then be slid into the main tube and the

chain looped over the chainring. The boom can

be set to the length required and the two pinch

bolts tightened to the recommended torque, see

Appendix A

NOTE – Tighten the pinch bolts evenly to prevent

damage to the frame

ADJUSTING THE TIMING CHAIN

The timing chain can be tensioned by undoing the

quick release on the tensioner arm and rotating

the arm to take up the slack in the chain. If the

tensioner alone can't take up the slack in the

chain, it is possible to shorten the timing chain by

removing some chain links.

INSTALLING THE FRONT STAND

(Optional extra) The bike is packed with the lower

stand brace fitted to the down tube, the main

section of the stand is packed separately in the

small parts box. The stand mounts to the frame at

two points; the upper clamp, slides over the stoker

bars, as shown earlier in the manual. The lower

mount is via the brace, the arms of the brace need

to be bolted to the main body of the stand using

the supplied nut and bolts.

INSTALLING THE KIDDY SYSTEM

(Optional extra) The Kiddy system main body

should be mouted to the main tube of the tandem,

the crank assembly will be pocked separately in

the small parts box.

To mount the crank assembly to the main body, the

T nuts need to be aligned with the corresponding

slots in the main body.

NOTE – It's easier to mount the T nuts to the channel

if one T nut has the long end facing out with the

opposite side T nut facing in.

Circe Cycles