digico SD10 Gebruikershandleiding - Pagina 15

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} digico SD10. digico SD10 20 pagina's. Replacing and cleaning faders
Ook voor digico SD10: Handmatig (9 pagina's)

Pagina afdrukken
digico SD10 Gebruikershandleiding
Chapter 1 - Getting Started

1.3.5 The Assigned Channel .........................................................

One of the channels in the Channel Strip panel is displayed in gold, indicating that it is currently the Assigned Channel. This means
that it has been assigned to the worksurface controls and can be configured in detail, as described below. To Assign a channel,
touch anywhere in the channel on the screen (except the Aux Send area).
Once a channel is Assigned, all of the controls for that channel which are not displayed within the channel strip itself can be
accessed via secondary pop-ups, displayed by touching inside the relevant area of the channel. These pop-ups include controls
such as input and output routing and signal processing parameters.
A number of the physical rotary encoders on the control surface can be assigned to different on-screen pots. In order to ensure
that it is clear which function is assigned to which encoder, the assigned on-screen pot will have a coloured ring around it.
The twelve encoders and buttons immediately above the touchscreen refer to the channels with which they are aligned. These
controls are concerned with the channel input, located at the top of the Channel Strip panel.
The three rows of encoders and buttons immediately below the touchscreen also refer to the channels with which they are
aligned. Normally, the upper two rows control the level and on/off status of the two highlighted aux sends, but can have a number
of functions assigned to them. Touching on an aux send on the screen will assign that aux and the ones immediately below it to
the aux encoders. Six of the aux sends can be displayed in the Channel Strip panel at any one time. If more than six aux sends
have been created in the session, the scroll buttons outside the bottom left-hand corner of the screen can be used to scroll the
display through the remaining auxiliaries. The third row is assigned to channel pan by default.
The controls to the right of the Channel Strip panel allow the Assigned channel to be adjusted:

1.3.6 The Master Fader ..................................................................

By default, the master fader is assigned to the master group output, which is the lowest stereo group output by default. In
addition, the master fader can be assigned to the solo buss output.
1-7