Creda Non pumped Installatie- en gebruikershandleiding - Pagina 10
Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} Creda Non pumped. Creda Non pumped 10 pagina's. Thermostatic digital mixer shower electronic remote control mixer shower
Pagina afdrukken
- The automatic bleed process takes 2 minutes to complete. During this time the internal pump
will switch on twice for about 10 seconds and water should come out of the shower handset.
- If water does not flow from the shower at the end of the bleed process, then press the program
buttons again, as shown, for 3 seconds.
- After 2 minutes the unit automatically switches off.
Once started, the bleed process can be stopped at any time by pressing the Start / Stop button.
• To bleed the air from the Non Pumped base unit :
- Make sure the cold and hot delivery pipes are primed prior to connection. (See above)
- Make sure the power to the base unit has been on for LESS than 5 minutes.
- Press the Start / Stop button. This will switch the unit on and also bleed any trapped air
Notes :
a) Pressing the two Program buttons is used to bleed the air from a Pumped unit. On a Non
Pumped unit these two buttons will have no effect. (Use the Start / Stop button instead).
b) The bleed process must be started in the first 5 minutes of switching on the power to the base
unit. Switch the power off and on again if it has been on for more than 5 minutes.
Synchronise the remote control to the base unit
The remote control leaves the factory "unsynchronised". It
automatically synchronised to its base unit when the buttons are
pressed to bleed out the air (see above).
If the buttons have no effect then the remote control can be reset and
"resynchronised" to the base as follows.
• Turn off the power supply to the base unit.
• Remove batteries from the remote and then put them back
again
• Leave the battery cover off
• Press the start button and then turn the remote over and press the "Reset" button (use a biro or
similar) for at least 3 seconds. (The remote will automatically switch off after 10 s. If the Reset
has not been done in this time, then press the Start button again).
• The remote will give a series of long and short bleeps to acknowledge the reset.
• Replace the battery cover, including the fixing screws.
• Switch on the power supply to the base unit and carry out the bleed process as described above.
Adjusting the remote control
Inside the battery compartment are 4 small "DIP"
switches that are used to set various features on the
shower. Use these DIP switches to set the following
features on the shower.
_10_
DIP 1 : Automatic switch off
(The shower will automatically switch off if no buttons are pressed for a pre-set time)
Use DIP switch 1 to set how long before the shower automatically switches off
ON = 20 minutes
OFF = 10 minutes
DIP 2 : Restrict range of adjustment of Temperature buttons
(The temperature can be restricted to a range that is suitable for less abled users)
Use DIP switch 2 to set a restriction on the temperature adjustment range
ON = Temperature can be fully adjusted between L (approx 25°C) and H (approx 46°C)
OFF = Temperature adjustment is restricted between 1 (approx 34°C) and 5 (approx 40°C)
DIP 3 : Stop the water flow being adjusted to maximum setting
(Flow can be limited to about half its maximum setting, used for saving water and energy)
Use DIP switch 3 to stop the flow buttons from adjustment to its maximum value.
ON = Full flow adjustment, minimum to maximum (approx 6 to 12 litres per minute)
OFF = Flow cannot be adjusted above about 7 litres a minute.
DIP 4 : Fix the flow rate (no flow adjustment possible)
(The flow rate can be fixed with the flow buttons unable to adjust the flow)
This switch MUST be set to Off when the plumbing scheme uses a combi boiler (See Page 7)
Use DIP switch 4 to fix the flow rate to about ¾ of maximum (approx 9 litres per minute).
ON = Full flow adjustment (approx 6 to 12 litres per minute) (Unless DIP 3 is set to OFF)
OFF = Flow rate is always set to about ¾ of maximum (and DIP 3 is automatically disabled)
_11_