Archer VR6 Installatie, bediening en onderhoud - Pagina 2

Blader online of download pdf Installatie, bediening en onderhoud voor {categorie_naam} Archer VR6. Archer VR6 5 pagina's. Vacuum regulator

Installing the VR6 Vacuum Regulator:

1) Carefully inspect the cylinder valve outlet surfaces and vacuum regulator inlet capsule

surfaces for damage or debris prior to installation.

2) Note that the inlet port on the VR6 regulator ships with a filter cartridge installed. Do not

remove this filter, as doing so will bring on maintenance requirements.

3) Always use a new lead gasket when connecting the vacuum regulator to a chlorine

cylinder valve.

4) Holding the vacuum regulator upright, settle it over the cylinder valve and fit the inlet

capsule into the cylinder valve outlet port.

5) Using a 3/8" wrench, tighten the yoke assembly "half-dog" set screw so that the lead

gasket is crushed between the valve and the inlet capsule.

6) Connect the vent and vacuum tubing to the regulator (these are labeled). See Figure 1.

NOTE: Vent tubing should always be connected and run to a safe location (outside of any

building). A vent bug cap (provided with every Archer vacuum regulator) should be fitted

over the end of vent tubing to prevent insects from entering the equipment.