digigate slider ROBO 24 Handmatig

Blader online of download pdf Handmatig voor {categorie_naam} digigate slider ROBO 24. digigate slider ROBO 24 7 pagina's. Sliding gate operator

SLIDING GATE OPERATOR

Introduction

The Nice 24 Sliding Gate Controller was designed to take advantage of

the superior torque and power of the 24 Volt motor. Conceived as a "Dual Supply"

system, the operator runs efficiently on the 220Volt Mains supply under normal

conditions, and, changing over seamlessly, continues to run from the on-board

batteries during a power failure. A switch mode power supply is used to convert the

mains to the 24 Volt power for the motor, the controller and accessories, and the

charging circuit, which ensures that the batteries are fully charged at the correct

voltage for long life.

Performance Using micro-processor control to provide ramp-up and ramp-down

speed control, the Nice 24 starts smoothly, accelerates quickly to full speed (16,7metres

per minute, one of the fastest operators available), slows down in the last half metre of

travel and stops firmly and gently under electronic braking.

Designed to operate without limit switches for ease of installation, the unit "learns" the

full extent of the gates travel by physically sensing the rail-stops, and then automatically

leaves a small safety gap at each end during normal operation, eliminating noisy

knocking.

Features

Easy Programming An on-board display makes it easy to select and enter the required

features, which include Learning Limits, Auto-close (none, 5, 10 or 20 seconds), Safety

beam selection, Obstacle Sensing Level, Recording Remote controls (up to 16), and

Type of operation, which may be 'Standard' (Residential) or 'Commercial'.

On-board Radio Receiver

The controller has a Digitronic e-Key receiver on board that

provides state-of-the-art secure access control using Keeloq code-hopping technology.

The receiver stores up to 16 transmitters in non-volatile memory.

Optional external Lamp

External 220V lamps may be connected to the controller,

which will come on with every gate operation, and time-out 3 minutes later. These

lamps may turned or off by means of a connection to the intercom. The combined

power of these lamps is restricted to 250W.

Easy Installation

Connections to the controller are made by means of plug-able

terminal blocks, simplifying installation and maintenance. These connections include

the intercom connection, partial opening for pedestrians, lock, safety beam, etc.

The configuration of the machine and the transmitter are stored in a plug-able memory

chip, which can be easily transferred to a replacement controller, making re-

programming un-necessary.

Installation Install the operator according to the enclosed instructions.

Important! For safety reasons, the gate must have physical end-stops in both the closed

and open positions. A sturdy rail-stop must be securely fitted to the track of the sliding

gate in the fully open position. In the closed position, the gate normally stops against the

gatepost. If not, a sturdy rail-stop must be securely fitted in the closed position as well.