FIAMA P1X Handmatig - Pagina 7

Blader online of download pdf Handmatig voor {categorie_naam} FIAMA P1X. FIAMA P1X 11 pagina's.

Pagina afdrukken

: to reduce the error made by truncating the digits after the radix point in the value to be displayed, it

NOTE

is advisable to multiply

number of significant digits; with the above mentioned values by multiplying everything by 100 it is

possible to obtain

for

15) Number of decimals

It sets the number of decimals of the display that can be set between 0 to 5.

16) Preset dimension

Value of the dimension that will be displayed by using the zero setting function or by enabling the

input in the terminal box according to what was set in the following constant.

17) Zero setting mode

The setting of the zero setting mode enables to select the effect of the E key or of the

according to the following table:

Modes 9 and 10 refer to the zero research automatic cycle (see on page 3) the zero setting/presetting or

zero research function).

Zero automatic research mode1

In the automatic zero setting function when the

axis is started searching for the zero input. When the zero point is reached the axis motion continues for

2 seconds more and then stops and carries out the dimension presetting.

Zero automatic research mode 2

In the automatic zero setting function when pressing the

is started searching for the zero input. When the zero point is reached the axis is stopped and the

dimension presetting is carried out.

18) Dimensions protected by password

In order to prevent the accidental or unintentional alteration of the positioning dimensions, the instrument

gives the opportunity to protect with a password the access to the dimensions. It is thus possible to select

between 0 , dimensions protected by password, and 1 ,dimensions unprotected by password.

24) Dimensions lower limit

Due to safety reasons the positioner prevents the entry of dimensions lower than the value set in this

constant and interrupts the axis motion if during the positioning the dimension becomes lower than this

limit. Don't set values that are upper then the Upper Limit for the values (next constant) or the positioner

will not accept the start drives

data: 13/01/16

and

by 10 or 100 or 1000 in order to consider the maximum

=123456 and

=10000 by thus obtaining 6 significant digits (instead of 4)

KEY

DISABLED

RESET

PRESET

RESET

PRESET

RESET

PRESET

DISABLED

START

file: P1X_ing.doc

RESET

PRESET

RESET

PRESET

DISABLED

PRESET in zero automatic

research mode 1

PRESET in zero automatic

research mode 2

- key is pressed the slow backward motion of the

- key the slow backward motion of the axis

START

PRESET

input

PRESET

INPUT

pag 7 di 11