FIAMA P1X Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} FIAMA P1X. FIAMA P1X 11 pagina's.

25) Dimensions upper limit

As for the previous constant, the positioner prevents the entry of dimensions exceeding the value set in

this constant and interrupts the axis motion if during the positioning the dimension exceeds this limit. Don't

set the values that are lower then the Lower Limit for the values (previous constant) or the positioner will

not accept the start drives.

26) Display mode

Setting this function gives the possibility to convert the quota visualized on the display in a quota

expressed in inch fraction or degrees. Keeping pressed the key P for abt. 3 seconds is possible proceed

to a type of visualization to an other.

The constant

select the visualization needed according to the following table

INPUTS/OUTPUTS TEST (TEST)

In order to have access to the test function it is necessary to enter the password 273.

In the inputs test function display3 will display the

hyphens. Every hyphen indicates one input: the input in the low position (high) indicates that the input is open

(closed).

The inputs test consists in closing the input switches and check that the display corresponds to the figure

below:

Then go to the outputs test by pressing the E key; the display3 will display

In order to enable/disable the outputs press the numerical keys indicated in the following figure: the position of

the hyphen indicates the output status; to the hyphen in the high position (low) corresponds an enabled output

(not enabled).

data: 13/01/16

defines the type of conversion of the quota: using keys START- and START+

DISPLAY FUNCTION

From tenth of mm to thousandths of an inch

From tenth of mm to hundredths of an inch

From mm to hundredths of an inch

From mm to tenths of an inch

From cm to hundredths of an inch

Sexagesimal degrees with display in degrees and prime numbers

Sexagesimal degrees with display in degrees

DISPLAY2

file: P1X_ing.doc

disabled

From dm to inches

(Test Input) message and display2 will display 4

INPUT CLOSED

NONE

START

PRESET

PIECESCOUNTER

EMERGENCY

(Test Output).

pag 8 di 11