Digimax 210 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Digimax 210. Digimax 210 12 pagina's. Programmable thermostat compatible with maxi controller
Ook voor Digimax 210: Gebruikershandleiding (11 pagina's)

Pagina afdrukken

RF Receiver Led's (indicators) :

Red Led :

'flashing' :

'steady on' :

'slowly plusing' : indicates a valid install code has been

Green Led :

'steady on' : - indicates demand for heat

'off' :

b) Checking the hard wired circuit :

1. Rely the RF-Max receiver to the mains. Check that no ther-

mostat in the heating network request warm. The red LED

should be off.

2. Press the Test button. The Green Led should come on.

Check that the boiler and/or motorised valve have been

operated. Remember to allow adequate time for the valve

to open. Press Test button again. The green led should

go out closing any valve and switching off the boiler.

Nota : the thermostat automatically leaves the test mode

after 15 minutes.

c) Checking the RF circuit

1. To install thermostat with the RF receiver press and hold

the OK and COPY keys together in Auto mode for 3

seconds. The DigiMax 210 will then transmit its unique

digital code every 10 seconds for the next 5 minutes. The

display will show flash ']]]' while this is happening.

indicates receiving an RF signal

indicates a fault condition e.g. RF signal

not being received

received

- no demand for heat i.e. heating call

satisfied