Cisco 300 Series Snelstarthandleiding - Pagina 11

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cisco 300 Series. Cisco 300 Series 17 pagina's. Managed switches
Ook voor Cisco 300 Series: Gegevensblad (14 pagina's), Snelstarthandleiding (18 pagina's), Snelstarthandleiding (17 pagina's)

Pagina afdrukken

Troubleshoot Your Connection

If you cannot access your switch from the web-based interface, the switch

may not be reachable from your computer. You can test network

connections by using ping on a computer running Windows:

Open a command window by using Start > Run and enter cmd.

TEP

At the Command window prompt enter ping and the managed

TEP

switch IP address. For example ping 192. 1 68. 1 .254 (the

default static IP address of the managed switch).

If you can reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Reply from 192.168.1.254: bytes=32 time<1ms TTL=128

If you cannot reach the switch, you should get a reply similar to the

following:

Pinging 192.168.1.254 with 32 bytes of data:

Request timed out.

Possible Causes and Resolutions

Bad Ethernet connection:

Check the LEDs for proper indications. Check the connectors of the

Ethernet cable to ensure they are firmly plugged into the switch and

your computer.

Bad Console port connection:

Check the console cable connectors to make sure they are firmly

plugged into the switch and your computer. Make sure the console

port utility is configured with the correct parameters.

Wrong IP address:

Make sure you are using the correct IP address for the switch. You can

determine the status of how the switch obtained the current IP address

by observing the system LED. You can determine the current IP

address of the switch through the console port interface by using the

CLI, or from your network administrator.

Make sure that no other device is using the same IP address as the

switch.

No IP route:

If the switch and your computer are in different IP subnets, you need

one or more routers to route the packets between the two subnets.

300 Series Managed Switches