Cisco 300 Series 빠른 시작 매뉴얼 - 페이지 11
{카테고리_이름} Cisco 300 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 300 Series 17 페이지. Managed switches
Cisco 300 Series에 대해서도 마찬가지입니다: 데이터시트 (14 페이지), 빠른 시작 매뉴얼 (18 페이지), 빠른 시작 매뉴얼 (17 페이지)
페이지 인쇄
Troubleshoot Your Connection
If you cannot access your switch from the web-based interface, the switch
may not be reachable from your computer. You can test network
connections by using ping on a computer running Windows:
Open a command window by using Start > Run and enter cmd.
S
1
TEP
At the Command window prompt enter ping and the managed
S
2
TEP
switch IP address. For example ping 192. 1 68. 1 .254 (the
default static IP address of the managed switch).
If you can reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Reply from 192.168.1.254: bytes=32 time<1ms TTL=128
If you cannot reach the switch, you should get a reply similar to the
following:
Pinging 192.168.1.254 with 32 bytes of data:
Request timed out.
Possible Causes and Resolutions
Bad Ethernet connection:
Check the LEDs for proper indications. Check the connectors of the
Ethernet cable to ensure they are firmly plugged into the switch and
your computer.
Bad Console port connection:
Check the console cable connectors to make sure they are firmly
plugged into the switch and your computer. Make sure the console
port utility is configured with the correct parameters.
Wrong IP address:
Make sure you are using the correct IP address for the switch. You can
determine the status of how the switch obtained the current IP address
by observing the system LED. You can determine the current IP
address of the switch through the console port interface by using the
CLI, or from your network administrator.
Make sure that no other device is using the same IP address as the
switch.
No IP route:
If the switch and your computer are in different IP subnets, you need
one or more routers to route the packets between the two subnets.
300 Series Managed Switches
11