Accusplit AX602M500 Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Accusplit AX602M500. Accusplit AX602M500 15 pagina's. Digital quartz stopwatches

Pagina afdrukken

1. How to Delete All Memory Segments

44-45

Stroke/Stride Measurement

Press [MODE] until you enter the Stroke Measure-

ment mode. The display will be as follows.

STROkE

In the Stroke or Strides Measurement mode,

the duration of 3 strokes is taken and the stroke

frequency (counts per minute) is calculated. If the

stroke frequency falls out of the range of 10 - 180,

"Err" will appear to show the error condition.

Press [START • SPLIT] to start the measurement.

During the 1st second, 180.0 will be shown and

ﬂ ashing as below.

46-47

Speed Mode

(AX602M500 Model only)

Press [MODE] until you enter the Speed mode.

The display will be as follows.

Distance indicator (only

used in speed mode

(Note that the default setting is KM. Hence "KM"

icon will be ON.)

The upper line shows the distance or speed. The

lap time is in the middle line, while the total time

is displayed on the lower line.

0.0

° Distance

° Lap time

° Total time

STROkE

At the end of the ﬁ rst second, the display will

become steady.

If measurement is stopped in the ﬁ rst second

(stroke frequency > 180), error signal " Err " will

be shown. After the ﬁ rst second has elapsed,

the instantaneous measurement reading will

be shown. When you press [STOP • RESET], the

display will show the steady stroke measurement

reading. If the measurement lasts for more than

18 seconds (stroke frequency < 10), an error signal

"Err" will be displayed. When the measurement

is stopped, press [STOP • RESET] to reset the

displayed reading to "0.0" .

In Speed mode, you can record a number of lap

times and speeds for covering the distance you

program into the chronograph. Before starting to

use the Speed mode, you need to enter the dis-

tance as explained below. Otherwise, the speed

measurement won't work. Nothing will happen

when you press [START • SPLIT].

Distance Setting

Press [RECALL] (S1) for 2 seconds to enter setting

mode. The unit icon ﬂ ashes.

180.0

Distance units