Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Installatie Opmerking - Pagina 14

Blader online of download pdf Installatie Opmerking voor {categorie_naam} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 24 pagina's. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ook voor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installatie Opmerking (14 pagina's), Oplossingshandleiding (17 pagina's), Installatie Opmerking (46 pagina's), Witboek (19 pagina's), Beschrijving (1 pagina's), Product Bulletin (6 pagina's), Kennisgeving (4 pagina's), Gegevensblad (9 pagina's), Gegevensblad (18 pagina's), Witboek (18 pagina's), Configuratiehandleiding (8 pagina's), Installatie Opmerking (28 pagina's), Handleiding voor probleemoplossing (11 pagina's), Installatie Opmerking (18 pagina's), Gebruikershandleiding (17 pagina's), Handmatig (19 pagina's), Installatie Opmerking (36 pagina's)

Installing the CSM

Figure 4

Failure to fully seat the module in the backplane connector can result in error messages.

Note

Tighten the two captive installation screws on the supervisor engine or module.

Note

Make sure that the ejector levers are fully closed before tightening the captive installation screws.

Vertical slots

Position the supervisor engine or switching module in the slot. (See

align the sides of the switching-module carrier with the slot guides on the top and bottom of the slot.

Catalyst 6500 Series Switch Content Switching Module Installation Note

Ejector Lever Closure in a Horizontal Slot Chassis

WS-X6K-SU P2-2GE

CONSOLE

PORT

MODE

CONSOLE

SUPERVIS OR2

PCMCIA

WS-X6K-SU P2-2GE

CONSOLE

PORT

MODE

CONSOLE

SUPERVIS OR2

PCMCIA

WS-C650 0-SFM

SWITCH FABRIC MDL

Ejector levers flush

with module faceplate

Switch

Load

100%

PORT 1

PORT 2

EJECT

Switch

Load

100%

PORT 1

PORT 2

EJECT

Figure

5.) Make sure that you

78-15751-01