Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Handmatig - Pagina 11

Blader online of download pdf Handmatig voor {categorie_naam} Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 pagina's. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ook voor Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion: Installatie Opmerking (14 pagina's), Oplossingshandleiding (17 pagina's), Installatie Opmerking (46 pagina's), Witboek (19 pagina's), Beschrijving (1 pagina's), Product Bulletin (6 pagina's), Kennisgeving (4 pagina's), Gegevensblad (9 pagina's), Gegevensblad (18 pagina's), Witboek (18 pagina's), Configuratiehandleiding (8 pagina's), Installatie Opmerking (28 pagina's), Handleiding voor probleemoplossing (11 pagina's), Installatie Opmerking (18 pagina's), Gebruikershandleiding (17 pagina's), Installatie Opmerking (24 pagina's), Installatie Opmerking (36 pagina's)

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Before connecting the console port, check the terminal documentation to determine the baud rate. The

baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the

terminal as follows:

9600 baud

8 data bits

No parity

1 stop bit

Connecting a Terminal to the Catalyst 5000

Supervisor Engine II G and III G Console and RSFC

Ports

The switch console port and the RSFC console port are located on the Supervisor Engine front panel and

are labeled "CONSOLE" and "RSFC" respectively, as shown above. Both ports are EIA/TIA-232

asynchronous, serial, full-featured data terminal equipment (DTE) connections with hardware flow

control and RJ-45 connectors.

Note: If you need a replacement console port accessory kit for your Supervisor Engine IIG or IIIG, the

part number is ACS-2500ASYN=. This is the same kit that ships with many other Cisco routers,

including the Cisco 2500 series.

The type of cable used to connect to a SupIIG or IIIG console port depends on the position of the console

port mode switch. Please refer to

For more information on accessing a Supervisor Engine IIG or IIIG remotely, see

to the Console Port on Catalyst

Use a null-modem cable to connect the switch to a remote data communications equipment (DCE)

device, such as a modem. For more information on accessing an Supervisor Engine IIG or IIIG remotely,

see

Connecting a Modem to the Console Port on Catalyst

connect the switch to a DTE device, such as a terminal or a PC.

http://www.cisco.com/warp/public/473/9.html (11 of 19) [9/4/2003 12:36:03 PM]

Console Port Mode Switch

Switches.

for more information.

Switches. Use a straight-through cable to

Connecting a Modem