Cisco 9134 - MDS Multilayer Fabric Switch Configuratiehandleiding - Pagina 38

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco 9134 - MDS Multilayer Fabric Switch. Cisco 9134 - MDS Multilayer Fabric Switch 49 pagina's. Mds 9000 series
Ook voor Cisco 9134 - MDS Multilayer Fabric Switch: Specificaties (3 pagina's), Release Release (48 pagina's), Release Release (44 pagina's), Release Release (22 pagina's), Release Release (3 pagina's), Release Release (40 pagina's), Release-opmerkingen (10 pagina's), Handmatig (16 pagina's), Hardware installatiehandleiding (36 pagina's)

Figure 33 Create iSCSI Targets window

Click Create.

Select Admin > Save Conﬁguration from the Device Manager menu bar.

Repeat all of the above steps for the other C-Series switch.

The iSCSI-enabled C-Series Fibre Channel switch setup is now complete.

Creating an iSCSI host

The host iSCSI Initiator must log in to the EVA storage controller before LUNs may be created.

Initial iSCSI Initiator EVA login

The iSCSI Initiator must log in to the storage controller so that the EVA storage controller can recognize

the iSCSI Initiator's WWPN. By setting the controller port as a persistent target, the iSCSI Initiator will

reconnect to the storage controller after a power cycle or reboot.

From the Microsoft iSCSI Initiator Properties window's Targets tab, click Refresh

The two virtual targets are listed (one for each C-Series switch).

(Figure

34).