Siemens SIMATIC NET Installatiehandleiding - Pagina 16

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Siemens SIMATIC NET. Siemens SIMATIC NET 40 pagina's. Network components bus terminal
Ook voor Siemens SIMATIC NET: Gebruiksaanwijzing (29 pagina's), Gebruiksaanwijzing (50 pagina's), Gebruiksaanwijzing (28 pagina's), Montagehandleiding (6 pagina's), Productinformatie (6 pagina's), Installatiehandleiding (50 pagina's), Installatiehandleiding (40 pagina's), Referentiehandleiding (14 pagina's), Installatiehandleiding (34 pagina's), Installatiehandleiding (48 pagina's), Gebruiksaanwijzing (32 pagina's)

Installing the Device

This chapter describes how to install the device, including mounting the device,

connecting power, and connecting the device to the network.

Electrocution hazard – risk of serious personal injury and/or damage to

equipment

Before performing any maintenance tasks, make sure all power to the device has

been disconnected and wait approximately two minutes for any remaining energy

to dissipate.

IMPORTANT

This product contains no user-serviceable parts. Attempted service by unauthorized

personnel shall render all warranties null and void.

Changes or modifications not expressly approved by Siemens AG could invalidate

specifications, test results, and agency approvals, and void the user's authority to

operate the equipment.

IMPORTANT

This product should be installed in a restricted access location where access can only

be gained by authorized personnel who have been informed of the restrictions and

any precautions that must be taken. Access must only be possible through the use

of a tool, lock and key, or other means of security, and controlled by the authority

responsible for the location.

2.1

The RUGGEDCOM RS8000T is designed for maximum mounting and display

flexibility. It can be equipped with connectors that allow it to be installed in a 48 cm

(19 in) rack, 35 mm (1.4 in) DIN rail, or directly on a panel.

IMPORTANT

Heat generated by the device is channeled outwards from the enclosure. As such, it

is recommended that 2.5 cm (1 in) of space be maintained on all open sides of the

device to allow for some convectional airflow.

Forced airflow is not required. However, any increase in airflow will result in a

reduction of ambient temperature and improve the long-term reliability of all

equipment mounted in the rack space.

RUGGEDCOM RS8000T

Installation Manual, 01/2021, C79000-G8976-1023-05

DANGER