Siemens SITRANS WW310 Gebruiksaanwijzing - Pagina 17

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Siemens SITRANS WW310. Siemens SITRANS WW310 48 pagina's. Weighfeeders

Step 5

Note

If your system has a permanently lubricated gear motor, then disregard this step, and

proceed directy to Step 6 (Page 15).

Check the gear reducer oil level. See the gear reducer information for further details on

maintenance.

Step 6

A de-dust port is provided on enclosed units at the discharge end. If no de-dust system is

required, this port should be closed.

Step 7

Connect the proper electric supply to the motor and/or motor controller. The AC or DC motor

controller (if present) must be grounded to minimize noise to the electronic integrator. Refer to

the applicable wiring diagram to make all electrical connections between the electronic integrator

and the weighfeeder.

Note

Units with a plugged discharge switch should refer to the wiring diagram included in the

CLS100 manual.

Step 8

Remove only the tagged shipping bolt that is attached to the load cell. This bolt supports the

weighbridge during transport and installation.

Note

DO NOT loosen or tighten the overload bolt—it has been factory set to minimize the

possibility of load cell damage resulting from incidental overload.

SITRANS WW310

Operating Instructions, 03/2014, A5E33490433-AA

Mechanical installation

5.1 Installation