Epson BrightLink 450Wi - Interactive Projector Installatie - Pagina 5

Blader online of download pdf Installatie voor {categorie_naam} Epson BrightLink 450Wi - Interactive Projector. Epson BrightLink 450Wi - Interactive Projector 5 pagina's. Remote control information
Ook voor Epson BrightLink 450Wi - Interactive Projector: Start hier Handleiding (6 pagina's), Brochure & specificaties (18 pagina's), Montagesjabloon (1 pagina's), Maattekening (2 pagina's), Montagesjabloon (5 pagina's), Gebruikershandleiding (25 pagina's), Snelstarthandleiding (2 pagina's), Gebruik (4 pagina's), Brochure & specificaties (18 pagina's), Installatie Handboek (10 pagina's)

(7) Determine the aspect ratio of the board or of the images that will be projected.

For new computers or laptops, this will most likely be WXGA (16:10). For older

equipment, this will most likely be XGA (4:3). You may need to consult your IT

director for this information.

4:3 XGA

(8) Using the tables in the Installation Guide for your aspect ratio and desired image

height (h), find the required distance between the top of the image area and the

wall plate (b).

(9) Determine the position for your projector installation by adding the values for (f ),

(h), and (b), plus an additional 10 inches for the height of the wall plate plus the

cover.

If the ceiling height of your room (as noted in step 1) does not meet the

minimum ceiling height required for your board, you may need to select a

smaller image size or move the board to a lower position on the wall.

(10)After confirming your image size, use tape or a pencil to mark the distance (b)

from the top of the image area on the board to the bottom of the wall plate.

(11)Align the

line (horizontal) on the template sheet with the (b) mark, then align

the center line on the template sheet with the center of the image area. Follow

the instructions in the Installation Guide to install the projector.

16:10 WXGA

16:9 Widescreen

_____ (b)

_____ (f )

_____ (h)

_____ (b)

+10

inches

_____ total

CPD-28016