Cisco 2500 Series Configuratiehandleiding - Pagina 12

Blader online of download pdf Configuratiehandleiding voor {categorie_naam} Cisco 2500 Series. Cisco 2500 Series 19 pagina's. Wireless controller
Ook voor Cisco 2500 Series: Handleiding installeren (12 pagina's), Uitrolhandleiding (23 pagina's), Configuratiehandleiding (50 pagina's), Aan de slag handleiding (47 pagina's)

Configuring the Access Server

Step 7

Step 8

Configuring the Asynchronous Interface

The access server is equipped with up to 16 asynchronous interfaces, which are referred to

as lines in the setup dialog. The asynchronous lines must be configured to permit

asynchronous devices to be connected to the access server. (See the sections

"Asynchronous Protocols," and "Modems" in the appendix "Internetworking Primer.")

The asynchronous ports on the access server are configured to allow connection by TTY

devices, Remote nodes, and Remote LANs.

A variety of devices can connect to the access server using the asynchronous lines.

Terminals and remote nodes (such as PCs, Macintosh computers, workstations, and host

systems) connect to the access server and make use of its services. The access server

provides services allowing access to other asynchronous devices, such as printers, modems,

or terminals.

The following steps configure the lines on the access server to permit use of the

asynchronous lines by the access server or remote devices:

Step 1

4-12 Cisco 2500 Series Access Server User Guide

In most cases you will use IP routing. If you are using IP routing, you must also

select an interior routing protocol. You can specify only one of two interior routing

protocols to operate on your system using setup: Interior Gateway Routing

Protocol (IGRP) or Routing Information Protocol (RIP).

Enter yes (the default) or press Return to configure IP, and then select an interior

routing protocol for IP:

Configure IP? [yes]:

Configure IGRP routing? [yes]:

Your IGRP autonomous system number [1]: 15

In this example, routing will be enabled on AppleTalk and IPX; IP has already

been selected:

Configure AppleTalk? [no]: yes

Multizone networks? [no]: yes

Configure LAT? [yes]: no

Configure IPX? [no]: yes

Enter yes or press Return to configure asynchronous lines:

Configure Async lines? [yes]: