Cisco NCS 4016 Uitpakken en installeren

Blader online of download pdf Uitpakken en installeren voor {categorie_naam} Cisco NCS 4016. Cisco NCS 4016 8 pagina's. Network convergence system
Ook voor Cisco NCS 4016: Handmatig (24 pagina's), Handleiding uitpakken, verplaatsen en vastzetten (40 pagina's), Installing (31 pagina's)

Pagina afdrukken

Unpacking the Chassis

This chapter describes how to unpack the Cisco NCS 4016 chassis.

Caution

Use the complete Cisco Systems packaging for shipment of product or components. Failure to properly use

Cisco packaging may result in damage or loss of the product.

•

Unpacking the Chassis

The chassis is shipped on a pallet by itself and is enclosed in a corrugated box, held in place by plastic bands.

Prerequisites

Before performing this task, be sure to have sufficient room around the chassis pallet for unpacking.

Required Tools and Equipment

• Cutters to cut strapping (plastic bands)

Steps

To unpack the Cisco NCS 4016 chassis, follow these steps:

SUMMARY STEPS

1. Carefully move the pallet containing the Cisco NCS 4016 chassis to the staging area where you plan on

unpacking it.

2. Cut the plastic bands holding the chassis shipping box in place.

3. Remove the six plastic clips on the outer sleeve using a flat head screw driver.

4. Remove the accessories, corrugated accessory tray and the top foam cap.

5. Leave the chassis on the pallet until you are ready to move and install the chassis in a rack.

DETAILED STEPS

Step 1

Carefully move the pallet containing the Cisco NCS 4016 chassis to the staging area where you plan on unpacking it.

Unpacking the Chassis, on page 1

Unpacking the Chassis