Cisco WAP300N Gebruikershandleiding - Pagina 22

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Cisco WAP300N. Cisco WAP300N 30 pagina's.
Ook voor Cisco WAP300N: Handmatig (9 pagina's)

Pagina afdrukken

Linksys WAP300N

Setting Up: Advanced

How to set up the MAC filter

For: Access Point mode only

When your WAP300N is in Access Point mode, you can filter access to your

wireless network by specifying Wi-Fi MAC addresses of the wireless devices

within range of your network

To set up the MAC filter:

Wireless > Wireless MAC Filter

1. Log into the browser-based utility (see "How to open the browser-based

utility" on page 8)

2. Click the Wireless tab, then click the Wireless MAC Filter page

3. Configure the following settings:

Wireless MAC Filter—To filter wireless devices by MAC address, select

Enabled If you do not want to filter by MAC address, keep the default

setting, Disabled

Access Restriction—To block wireless access by MAC address, select

Prevent To allow wireless access by MAC address, select Permit

MAC 01-32—Enter the Wi-Fi MAC addresses of the devices you want to

block or allow

4. Optional: Click Wireless Client List to open the Wireless Client List screen

This screen shows computers and other devices on the wireless network

The list can be sorted by MAC Address or by Status

To add a device to the list, select Save to MAC Address Filter List,

•

then click Add

To retrieve the latest network information, click Refresh

•

To return to the Wireless MAC Filter screen, click Close

•

5. Click Save Settings to apply your changes

Setting Up: Advanced