Cisco MX300 G2 Aan de slag handleiding - Pagina 17

Blader online of download pdf Aan de slag handleiding voor {categorie_naam} Cisco MX300 G2. Cisco MX300 G2 46 pagina's.
Ook voor Cisco MX300 G2: Installing (7 pagina's), Installing (7 pagina's), Snelle referentiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's), Snelle referentiehandleiding (2 pagina's)

Cisco TelePresence Video Systems

Contents

Configuration using TRC5 remote control and on-screen menu*

Waking up the system

If there is no menu on screen, press

Home

control to show the menu.

If the system does not show a menu on screen:

• Make sure the monitor is connected and has been switched

on.

• Make sure the remote control has batteries installed.

• Make sure the system is switched on.

If the system has just been switched on, wait a few minutes to

allow the system to start up.

If there is still no menu on screen, make sure the monitor cable

is connected to the basic video output connector. If in doubt,

see the installation guide for your product.

* This section does not apply for SX10, SX80, EX Series and MX Series.

Back to task overview

D14639.15 Video Systems Getting Started Guide TC7.2, OCTOBER 2014.

Introduction

User interfaces

(

) on the remote

Configuration

Remote control and

on-screen menu

Getting Started Guide

Appendices

Contacts