Cisco TelePresence IX5200 Eerste installatie - Pagina 6

Blader online of download pdf Eerste installatie voor {categorie_naam} Cisco TelePresence IX5200. Cisco TelePresence IX5200 40 pagina's.
Ook voor Cisco TelePresence IX5200: Gebruikershandleiding Snel aan de slag (15 pagina's), Gebruikershandleiding (26 pagina's), Installatiehandleiding (36 pagina's)

Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System

Tip

For an IX5200, configure the device type as Cisco TelePresence IX5000 (18 seats).

Load the Cisco TelePresence Administration Software image on the Unified CM server.

Step 2

If your Unified CM has already loaded the required IX5000 software, you can skip this step.

Note

Step 3

Add your system as a device in Unified CM. For more information, refer to the

to Unified CM"

document.

Add the TFTP server(s) used by the Unified CM server to your system using the IX System

Step 4

administration GUI. Complete the following steps:

For more information about configuring Unified CM with your Cisco TelePresence device, refer to the

Configuring Cisco Unified Communications Manager for the IX System

Finding the MAC Address for Your System

You need the codec MAC address to configure your system in Unified CM. There are two MAC

addresses on the codec. Use the address that is nearest the Uplink and EX1 Ethernet connections.

Figure 1

You can also find this address on the blue screen while your system is booting up.

Tip

Cisco TelePresence IX5000 and IX5200 First-Time Setup

section in the

Log into the IX System administration GUI for your system as user admin. The default password is

cisco.

Click the Configuration icon (the gear on the left of the screen).

Scroll down to the Call Control Manager section.

Enter the TFTP Server(s) in the Call Control Manager area.

Click Apply.

provides an example.

Configuring Cisco Unified Communications Manager for the IX System

"Adding an IX System

document.

OL-27038-01