Cisco TelePresence IX5200 최초 설정 - 페이지 6
{카테고리_이름} Cisco TelePresence IX5200에 대한 최초 설정을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco TelePresence IX5200 40 페이지.
Cisco TelePresence IX5200에 대해서도 마찬가지입니다: 빠른 시작 사용 설명서 (15 페이지), 사용자 설명서 (26 페이지), 설치 매뉴얼 (36 페이지)
페이지 인쇄
Configuring Cisco Unified Communications Manager for Your Cisco TelePresence System
Tip
For an IX5200, configure the device type as Cisco TelePresence IX5000 (18 seats).
Load the Cisco TelePresence Administration Software image on the Unified CM server.
Step 2
If your Unified CM has already loaded the required IX5000 software, you can skip this step.
Note
Step 3
Add your system as a device in Unified CM. For more information, refer to the
to Unified CM"
document.
Add the TFTP server(s) used by the Unified CM server to your system using the IX System
Step 4
administration GUI. Complete the following steps:
a.
b.
c.
d.
e.
For more information about configuring Unified CM with your Cisco TelePresence device, refer to the
Configuring Cisco Unified Communications Manager for the IX System
Finding the MAC Address for Your System
You need the codec MAC address to configure your system in Unified CM. There are two MAC
addresses on the codec. Use the address that is nearest the Uplink and EX1 Ethernet connections.
Figure 1
You can also find this address on the blue screen while your system is booting up.
Tip
Cisco TelePresence IX5000 and IX5200 First-Time Setup
6
section in the
Log into the IX System administration GUI for your system as user admin. The default password is
cisco.
Click the Configuration icon (the gear on the left of the screen).
Scroll down to the Call Control Manager section.
Enter the TFTP Server(s) in the Call Control Manager area.
Click Apply.
provides an example.
Configuring Cisco Unified Communications Manager for the IX System
"Adding an IX System
document.
OL-27038-01